Operation Manual – DLDPH3C S3100 Series Ethernet Switches Chapter 1 DLDP Configuration1-12Table 1-10 Reset DLDP stateOperation Command Descriptionsystem-viewReset DLDP state for all theports shut down by DLDP dldp resetinterface interface-typeinterface-numberReset the DLDP state for a portshut down by DLDPdldp resetSelect either of the two.1.3.3 Displaying and Maintaining DLDPTable 1-11 Display and maintain DLDPOperation Command DescriptionDisplay the DLDPconfiguration of a unit ora portdisplay dldp { unit-id |interface-typeinterface-number }Available in any view.1.4 DLDP Configuration ExampleI. Network requirementsAs shown in Figure 1-3,z Switch A and Switch B are connected through two pairs of fibers. Both of themsupport DLDP. All the ports involved operate in mandatory full duplex mode, withtheir rates all being 1,000 Mbps.z Suppose the fibers between Switch A and Switch B are cross-connected. DLDPdisconnects the unidirectional links after detecting them.z After the fibers are connected correctly, the ports shut down by DLDP arerestored.