Operation Manual – MSTPH3C S3100 Series Ethernet Switches Chapter 1 MSTP Configuration1-59# Enter MST region view. system-view[Sysname] stp region-configuration# Configure the MST region.[Sysname-mst-region] region-name example[Sysname-mst-region] instance 1 vlan 10[Sysname-mst-region] instance 3 vlan 30[Sysname-mst-region] instance 4 vlan 40[Sysname-mst-region] revision-level 0# Activate the settings of the MST region manually.[Sysname-mst-region] active region-configuration# Specify Switch C as the root bridge of spanning tree instance 4.[Sysname] stp instance 4 root primary4) Configure Switch D# Enter MST region view. system-view[Sysname] stp region-configuration# Configure the MST region.[Sysname-mst-region] region-name example[Sysname-mst-region] instance 1 vlan 10[Sysname-mst-region] instance 3 vlan 30[Sysname-mst-region] instance 4 vlan 40[Sysname-mst-region] revision-level 0# Activate the settings of the MST region manually.[Sysname-mst-region] active region-configuration1.14 VLAN-VPN tunnel Configuration ExampleI. Network requirementsz Switch C and Switch D operate as the access devices of the operator’s network, inthe network diagram.z S3100-SI switches operate as the access devices of the user’s network, that is,Switch A and Switch B in the network diagram.z Switch C and Switch D are connected to each other through the configured trunkports of the switches. The VLAN-VPN tunnel function is enabled in system view,thus implementing transparent transmission between the user’s network and theoperator’s network.