Operation Manual – QoS-QoS ProfileH3C S3100 Series Ethernet Switches Chapter 1 QoS Configuration1-33I. Configuration prerequisitesThe burst function is required.II. Configuration procedureTable 1-33 Enable the burst functionOperation Command DescriptionEnter system view system-view —Enable the burstfunction burst-mode enableRequiredBy default, the burst function isdisabled.III. Configuration exampleEnable the burst function.Configuration procedure: system-view[Sysname] burst-mode enable1.4.11 Configuring Traffic MirroringNote:Only H3C S3100-EI series switches support this configuration.Refer to section Traffic Mirroring for information about traffic mirroring.I. Configuration prerequisitesz The ACL rules for traffic classification are defined. Refer to the ACL module of thismanual for information about defining ACL rules.z The destination mirroring port is determined.II. Configuration procedureYou can configure traffic mirroring on all the packets matching specific ACL rules, or onpackets that match specific ACL rules and are of a VLAN, of a port group, or pass aport.