Operation Manual – MirroringH3C S3100 Series Ethernet Switches Chapter 1 Mirroring Configuration1-7Table 1-5 Configuration on the intermediate switchOperation Command DescriptionEnter system view system-view —Create a VLAN and enterVLAN view vlan vlan-id vlan-id is the ID of theremote-probe VLAN.Configure the currentVLAN as theremote-probe VLANremote-probe vlanenable RequiredReturn to system view quit —Enter the view of theEthernet port connectingto the source switch,destination switch orother intermediate switchinterface interface-typeinterface-number —Configure the current portas trunk port port link-type trunkRequiredBy default, the port type isAccess.Configure the trunk port topermit packets from theremote-probe VLANport trunk permit vlanremote-probe-vlan-id RequiredIII. Configuration on a switch acting as a destination switch1) Configuration prerequisitesz The destination port and the remote-probe VLAN are determined.z Layer 2 connectivity is ensured between the source and destination switches overthe remote-probe VLAN.2) Configuration procedureTable 1-6 Configure remote port mirroring on the destination switchOperation Command DescriptionEnter system view system-view —Create a VLAN andenter VLAN view vlan vlan-id vlan-id is the ID of theremote-probe VLAN.Configure the currentVLAN as aremote-probe VLANremote-probe vlan enable RequiredReturn to system view quit —Enter the view of theEthernet port connectingto the source switch oran intermediate switchinterface interface-typeinterface-number —
