Operation Manual – FTP-SFTP-TFTPH3C S3100 Series Ethernet Switches Chapter 1 FTP and SFTP Configuration1-10 boot boot-loader switch.bin rebootNote:For information about the boot boot-loader command and how to specify the startupfile for a switch, refer to the System Maintenance and Debugging part of this manual.1.2.4 FTP Banner Display Configuration ExampleI. Network requirementsConfigure the Ethernet switch as an FTP server and the remote PC as an FTP client.After a connection between the FTP client and the FTP server is established and loginsucceeds, the banner is displayed on the FTP client.z An FTP user named “switch” and the password “hello” have been configured onthe FTP server.z The IP addresses 1.1.1.1 for a VLAN interface on the switch and 2.2.2.2 for thePC have been configured. Ensure that a route exists between the switch and thePC.z Configure the login banner of the switch as “login banner appears” and the shellbanner as “shell banner appears”.II. Network diagramIP networkFTP Server FTP ClientSwitchA PCVLAN-Int11.1.1.1/82.2.2.2/8Figure 1-4 Network diagram for FTP banner display configurationIII. Configuration procedure1) Configure the switch (FTP server)# Configure the login banner of the switch as “login banner appears” and the shellbanner as “shell banner appears”. For detailed configuration of other networkrequirements, see section 1.2.3 Configuration Example: A Switch Operating as an FTPServer. system-view[Sysname] header login %login banner appears%[Sysname] header shell %shell banner appears%