Operation Manual – HWPingH3C S3100 Series Ethernet Switches Chapter 1 HWPing Configuration1-21.1.2 Test Types Supported by HWPingTable 1-1 Test types supported by HWPingSupported test types DescriptionICMP testDHCP testFTP testHTTP testDNS testSNMP testFor these types of tests, you need to configureHWPing client and corresponding servers.Jitter testTcppublic testTCP testTcpprivate testUdppublic testUDP testUdpprivate testz These types of tests need the cooperation ofHWPing client and HWPing Server.z Do not perform a TCP, UDP or jitter test on awell-known port (ports with a number ranging from1 to 1023) or on a port with a port number greaterthan 50000. Otherwise, your HWPing test may failor the service corresponding to the well-knownport may become unavailable.Caution:H3C S3100-SI series Ethernet switches do not support HWPing DNS tests.1.1.3 HWPing Test ParametersYou need to configure corresponding test parameters for each type of HWPing test.HWPing test parameters can be configured on HWPing client only. For theconfigurations on HWPing client, refer to section 1.2.2 HWPing Client Configuration.Table 1-2 HWPing test parametersTest parameter DescriptionDestination address(destination-ip)For TCP/UDP/jitter test, you must specify adestination IP address, and the destinationaddress must be the IP address of aTCP/UDP/UDP listening service configured onthe HWPing server.Destination port(destination-port)For tcpprivate/udpprivate/jitter test, you mustspecify a destination port number, and thedestination port number must be the portnumber of a TCP or UDP listening serviceconfigured on the HWPing server.
