Operation Manual – Configuration File ManagementH3C S5600 Series Ethernet Switches Chapter 1 Configuration File Management1-5z While the reset saved-configuration backup command erases the configurationfile with backup attribute, it only erases the backup attribute of a configuration filehaving both main and backup attribute.Caution:This command will permanently delete the configuration file from the switch.1.2.3 Specifying a Configuration File for Next StartupUse the following command to specify a configuration file for next startup:To do… Use the command… RemarksSpecify a configuration filefor next startupstartupsaved-configurationcfgfile [ backup | main ]RequiredAvailable in user viewYou can specify a configuration file to be used for the next startup and configure themain/backup attribute for the configuration file.I. Assigning main attribute to the startup configuration filez If you save the current configuration to the main configuration file, the system willautomatically set the file as the main startup configuration file.z You can also use the startup saved-configuration cfgfile [ main ] command toset the file as main startup configuration file.II. Assigning backup attribute to the startup configuration filez If you save the current configuration to the backup configuration file, the systemwill automatically set the file as the backup startup configuration file.z You can also use the startup saved-configuration cfgfile backup command toset the file as backup startup configuration file.Caution:The configuration file must use .cfg as its extension name and the startup configurationfile must be saved at the root directory of the switch.