Operation Manual – CLIH3C S5600 Series Ethernet Switches Chapter 1 CLI Configuration1-4[Sysname] command-privilege level 0 view shell tftp 192.168.0.1 getbootrom.btmAfter the above configuration, general Telnet users can use the tftp get command todownload file bootrom.btm and other files from TFTP server 192.168.0.1 and otherTFTP servers.1.2.3 Switching User LevelComplete the following tasks to configure user level switching:Task RemarksSpecifying the authentication mode for user level switching OptionalAdopting super password authentication for user level switching RequiredAdopting HWTACACS authentication for user level switching RequiredSwitching to a specific user level RequiredI. Specifying the authentication mode for user level switchingYou can switch between user levels through corresponding commands after logginginto a switch successfully. The high-to-low user level switching is unlimited. However,the low-to-high user level switching requires the corresponding authentication. Thesuper password authentication mode and HWTACACS authentication mode areavailable at the same time to provide authentication redundancy.The configuration of authentication mode for user level switching is performed byLevel-3 users.Follow these steps to specify the authentication mode for user level switching:To do… Use the command… RemarksEnter system view system-view —Enter user interface view user-interface [ type ]first-number [ last-number ] —
