Operation Manual – PoE-PoE ProfileH3C S5600 Series Ethernet Switches Chapter 1 PoE Configuration1-3Note:z When you use the PoE-enabled S5600 switch to supply power, the PDs need noexternal power supply.z If a remote PD has an external power supply, the PoE-enabled S5600 switch andthe external power supply will backup each other for the PD.z Only the Ethernet electrical ports of the PoE-enabled S5600 switch support the PoEfeature.1.2 PoE Configuration1.2.1 PoE Configuration Task ListComplete the following tasks to configure PoE configuration:Task RemarksEnabling the PoE Feature on a Port RequiredSetting the Maximum Output Power on a Port OptionalSetting PoE Management Mode and PoE Priority of a Port OptionalSetting the PoE Mode on a Port OptionalConfiguring the PD Compatibility Detection Function OptionalConfiguring PoE Over-Temperature Protection on the Switch OptionalUpgrading the PSE Processing Software Online OptionalUpgrading the PSE Processing Software of Fabric SwitchesOnline OptionalDisplaying PoE Configuration Optional1.2.2 Enabling the PoE Feature on a PortFollow these steps to enable the PoE feature on a port:To do… Use the command… RemarksEnter system view system-view —Enter Ethernet port view interface interface-typeinterface-number —Enable the PoE feature ona port poe enable Required
