Operation Manual – Routing ProtocolH3C S5600 Series Ethernet Switches Chapter 4 OSPF Configuration4-224.6.4 Configuring the OSPF Cost on an InterfaceFollow these steps to configure the OSPF cost on an interface:To do... Use the command... RemarksEnter system view system-view —Enter interface view interface interface-typeinterface-number —Configure the OSPFcost on the interface ospf cost valueRequiredBy default, a VLAN interface onthe switch, a fixed value of 10 isused.4.6.5 Configuring OSPF Route PrioritySince multiple dynamic routing protocols may be running on one router, the problemof route sharing and selection between various routing protocols arises. The systemsets a priority for each routing protocol (which you can change manually), and whenmore than one route to the same destination is discovered by different protocols, thesystem add the route discovered by the protocol with the highest priority to the routingtable.Follow these steps to configure OSPF route priority:To do... Use the command... RemarksEnter system view system-view —Enter OSPF view ospf [ process-id [ router-idrouter-id ] ] —Configure OSPFroute priority preference [ ase ] valueRequiredBy default, the OSPF routepriority is 10 and the priority ofOSPF ASE is 150.4.6.6 Configuring the Maximum Number of OSPF ECMP RoutesFollow these steps to configure the maximum number of OSPF ECMP routes:To do... Use the command... RemarksEnter system view system-view —Enter OSPF view ospf [ process-id[ router-id router-id ] ] —