Operation Manual – LoginH3C S5600 Series Ethernet SwitchesChapter 7 Configuring Source IP Address for TelnetService Packets7-2To do… Use the command… Remarkstelnet { hostname | ip-address } [ service-port ]{ source-ip ip-address | source-interfaceinterface-type interface-number }system-viewSpecify a sourceIP address orsource interfacefor Telnet servicepackets for anS5600 switchserving as aTelnet clienttelnet { source-ip ip-address |source-interface interface-typeinterface-number }RequiredUse eitherapproachNote:z The IP address specified is that of a Layer 3 interface of the local device. Otherwise,the system prompts configuration failure.z The source interface specified must exist. Otherwise, the system promptsconfiguration failure.z Configuring the source interface of Telnet service packets equals configuring the IPaddress of this interface as the source IP address of the Telnet service packets.z If a source IP address (or source interface) is specified, you need to make sure thatthe route between the IP addresses (or interface) and the Telnet server isreachable.7.3 Displaying Source IP Address ConfigurationTo do… Use the command… RemarksDisplay the source IPaddress configured for theTelnet service packetsdisplay telnet source-ip Available in any view