Operation Manual – HWPingH3C S5600 Series Ethernet Switches Chapter 1 HWPing Configuration1-282 9 1 0 2000-04-02 15:15:52.53 3 1 0 2000-04-02 15:15:52.54 3 1 0 2000-04-02 15:15:52.55 3 1 0 2000-04-02 15:15:52.56 2 1 0 2000-04-02 15:15:52.47 3 1 0 2000-04-02 15:15:52.48 3 1 0 2000-04-02 15:15:52.49 2 1 0 2000-04-02 15:15:52.410 2 1 0 2000-04-02 15:15:52.4For detailed output description, see the corresponding command manual.Note:For an HTTP test, if configuring the destination address as the host name, you mustconfigure the IP address of the DNS server to resolve the host name into an IP address,which is the destination IP address of this HTTP test.1.3.5 Jitter TestI. Network requirementsBoth the HWPing client and the HWPing server are H3C S5600 series Ethernetswitches. Perform a HWPing jitter test between the two switches to test the delay jitterof the UDP packets exchanged between this end (HWPing client) and the specifieddestination end (HWPing server).II. Network diagramFigure 1-6 Network diagram for the Jitter testIII. Configuration procedurez Configure HWPing Server (Switch B):# Enable the HWPing server and configure the IP address and port to listen on. system-view[Sysname] hwping-server enable[Sysname] hwping-server udpecho 10.2.2.2 9000z Configure HWPing Client (Switch A):