Operation Manual – Port Basic ConfigurationH3C S5600 Series Ethernet Switches Chapter 1 Port Basic Configuration1-12To do... Use the command... RemarksDisplay the informationabout the ports with thelink-delay commandconfigureddisplay link-delay Available in anyviewDisplay brief informationabout port configurationdisplay brief interface[ interface-typeinterface-number ] [ | { begin |include | exclude } string ]Available in anyviewDisplay the combo ports display port combo Available in anyviewDisplay the storm controlconfigurations.display storm-constrain[ interface interface-typeinterface-number ] [ | { begin |exclude | include }regular-expression ]Available in anyviewDisplay port informationabout a specified unit display unit unit-id interface Available in anyviewDisplay port loopbackdetection information display loopback-detection Available in anyviewDisplay the statistics ondropped packetsdisplay packet-drop { interface[ interface-typeinterface-number ] | summary }Available in anyviewClear port statisticsreset counters interface[ interface-type | interface-typeinterface-number ]Available in userviewClear the statistics ondropped packetsreset packet-drop interface[ interface-typeinterface-number ]Available in userview1.2 Ethernet Port Configuration ExampleI. Network requirementsz Switch A and Switch B are connected to each other through two trunk port(GigabitEthernet1/0/1).z Configure the default VLAN ID of both GigabitEthernet1/0/1 to 100.z Allow the packets of VLAN 2, VLAN 6 through VLAN 50 and VLAN 100 to passboth GigabitEthernet1/0/1.