Operation Manual – Information CenterH3C S5600 Series Ethernet Switches Chapter 1 Information Center1-14To do… Use the command… RemarksEnable debugginginformation terminaldisplay functionterminal debugging OptionalDisabled by defaultEnable log informationterminal display function terminal logging OptionalEnabled by defaultEnable trap informationterminal display function terminal trapping OptionalEnabled by defaultNote:Make sure that the debugging/log/trap information terminal display function is enabled(use the terminal monitor command) before you enable the corresponding terminaldisplay function by using the terminal debugging, terminal logging, or terminaltrapping command.1.2.6 Setting to Output System Information to a Log HostFollow these steps to set to output system information to a log host:To do… Use the command… RemarksEnter system view system-view —Enable the informationcenter info-center enable OptionalEnabled by default.Enable information outputfor a specified switch in afabricinfo-center switch-on{ unit unit-id | master |all } [ debugging |logging | trapping ]*OptionalBy default, debugginginformation output isenabled, and log and trapinformation output aredisabled for the masterswitch in a fabric.Debugging, log and trapinformation output are alldisabled for otherswitches in the fabric.
