Operation Manual – QoS-QoS ProfileH3C S5600 Series Ethernet Switches Chapter 2 QoS Profile Configuration2-2The switch directly applies the QoS profile to the port the user is connected to.Note:A user-based QoS profile application fails if the traffic classification rule defined in theQoS profile contains source address information (including source MAC addressinformation, source IP address information, and VLAN information).II. Manual application modeYou can use the apply command to manually apply a QoS profile to a port.2.2 QoS Profile Configuration Task ListComplete the following tasks to configure QoS profile:Operation DescriptionConfiguring a QoS Profile RequiredApplying a QoS Profile Optional2.2.1 Configuring a QoS ProfileI. Configuration prerequisitesz The ACL rules used for traffic classification are defined. Refer to the ACL moduleof this manual for information about defining ACL rules.z The type and number of actions in the QoS profile are specified.II. Configuration procedureFollow these steps to configure a QoS profile:To do… Use the command… RemarksEnter system view system-view —Create a QoS profile andenter QoS profile view qos-profile profile-nameRequiredIf the specified QoS profilealready exists, you enterthe QoS profile viewdirectly.
