Operation Manual – Access ManagementH3C S5600 Series Ethernet Switches Chapter 1 Access Management Configuration1-2z A port with an access management IP address pool configured only allows thehosts with their IP addresses in the access management IP address pool toaccess external networks.z A port without an access management IP address pool configured allows thehosts to access external networks only if their IP addresses are not in the accessmanagement IP address pools of other ports of the switch.Note that the IP addresses in the access management IP address pool configured on aport must be in the same network segment as the IP address of the VLAN (where theport belongs to) interface.1.2 Configuring Access ManagementFollow these steps to configure access management:To do… Use the command… RemarksEnter system view system-view —Enable accessmanagement function am enableRequiredBy default, the systemdisables the accessmanagement function.Enable accessmanagement trap am trap enableRequiredBy default, accessmanagement trap isdisabledEnter Ethernet port view interface interface-typeinterface-number —Configure the accessmanagement IP addresspool of the portam ip-pool address-listRequiredBy default, no accessmanagement IP addresspool is configured.Display currentconfiguration of accessmanagementdisplay am[ interface-list ]Execute this command inany view.