Operation Manual – Smart Link-Monitor LinkH3C S5600 Series Ethernet Switches Chapter 1 Smart Link Configuration1-5To do… Use the command… Remarkssmart linkgroup viewport interface-type interface-number{ master | slave }quitinterface interface-typeinterface-numberConfigurea port as asmart linkgroupmemberEthernetport viewport smart-link group group-id{ master | slave }RequiredUse eitherapproachFollow these steps to configure Smart Link (with link aggregation groups are themembers of the smart link group):To do… Use the command… RemarksEnter system view system-view —Create a smart link groupand enter smart link groupviewsmart-link group group-id RequiredConfigure a linkaggregation group as amember of the smart linkgrouplink-aggregation groupgroup-id { master | slave } OptionalEnable the function ofsending flush messagesin the specified controlVLANflush enable control-vlanvlan-idOptionalBy default, no controlVLAN for sending flushmessages is specified.1.2.3 Configuring Associated DevicesAn associated device mentioned in this document refers to a device that supportsSmart Link and locally configured to process flush messages received from thespecified control VLAN so as to work with the corresponding Smart Link device. Asshown in Figure 1-2, all the devices including Switch C, Switch D, and Switch E on theactive and backup links connecting the Smart Link device (Switch A) and the targetuplink device (Switch E) are all associated devices.However, you do not have to enable all the ports of an associated device to processflush messages received from the specified control VLAN. You need to enable thisfunction only on the ports that are on the active and backup links connecting the SmartLink device and the target device. As shown in Figure 1-2, you need to enable thisfunction on GigabitEthernet 1/0/2 and GigabitEthernet 1/0/3 of Switch C,