Operation Manual – AAAH3C S5600 Series Ethernet Switches Chapter 2 AAA Configuration2-13Note:Actually, the RADIUS service configuration only defines the parameters for informationexchange between switch and RADIUS server. To make these parameters take effect,you must reference the RADIUS scheme configured with these parameters in an ISPdomain view (refer to AAA Configuration).2.2.1 Creating a RADIUS SchemeThe RADIUS protocol configuration is performed on a RADIUS scheme basis. Youshould first create a RADIUS scheme and enter its view before performing otherRADIUS protocol configurations.Follow these steps to create a RADIUS scheme:To do… Use the command… RemarksEnter system view system-view —Enable RADIUSauthentication port radius client enableOptionalBy default, RADIUSauthentication port is enabled.Create a RADIUSscheme and enter itsviewradius schemeradius-scheme-nameRequiredBy default, a RADIUS schemenamed "system" has alreadybeen created in the system.Note:A RADIUS scheme can be referenced by multiple ISP domains simultaneously.2.2.2 Configuring RADIUS Authentication/Authorization ServersFollow these steps to configure RADIUS authentication/authorization servers:To do… Use the command… RemarksEnter system view system-view —Create a RADIUS schemeand enter its viewradius schemeradius-scheme-nameRequiredBy default, a RADIUSscheme named "system"has already been createdin the system.