Operation Manual – VLAN-VPNH3C S5600 Series Ethernet Switches Chapter 1 VLAN-VPN Configuration1-3Refer to QoS-QoS Profile part for information about priority.1.2 VLAN-VPN Configuration1.2.1 VLAN-VPN Configuration Task ListComplete the following tasks to configure VLAN-VPN:Task RemarksEnabling the VLAN-VPN Feature for a Port RequiredConfiguring the Inner-to-Outer Tag Priority Replicating andMapping Feature OptionalCaution:As IRF fabric is mutually exclusive with VLAN-VPN, make sure that IRF fabric isdisabled on the switch before performing any of the configurations listed in the abovetable. For information about IRF fabric, refer to IRF Fabric Configuration in this manual.1.2.2 Enabling the VLAN-VPN Feature for a PortFollow these steps to enable the VLAN-VPN feature for a port:To do... Use the command... RemarksEnter system view system-view —Enter Ethernet portviewinterface interface-typeinterface-number —Enable the VLAN-VPNfeature on the port vlan-vpn enableRequiredBy default, the VLAN-VPNfeature is disabled on a port.1.2.3 Configuring the Inner-to-Outer Tag Priority Replicating and MappingFeatureMake sure that the VLAN-VPN feature is enabled on a port before configuring theinner-to-outer tag priority replicating and mapping feature.Follow these steps to configure the inner-to-outer tag priority replicating and mappingfeature: