Operation Manual – 802.1x and System GuardH3C S5600 Series Ethernet Switches Chapter 3 HABP Configuration3-2To do... Use the command... RemarksEnable HABP habp enableOptionalBy default, HABP isenabled.Configure the currentswitch to be an HABPserverhabp server vlan vlan-idRequiredBy default, a switchoperates as an HABPclient after you enableHABP on the switch. If youwant to use the switch asa management switch,you need to configure theswitch to be an HABPserver.Configure the interval tosend HABP requestpackets.habp timer intervalOptionalThe default interval for anHABP server to sendHABP request packets is20 seconds.3.3 HABP Client ConfigurationHABP clients reside on switches attached to HABP servers. After you enable HABP fora switch, the switch operates as an HABP client by default. So you only need to enableHABP on a switch to make it an HABP client.Follow these steps to configure an HABP client:To do... Use the command... RemarksEnter system view system-view —Enable HABP habp enableOptionalHABP is enabled bydefault. And a switchoperates as an HABPclient after you enableHABP for it.3.4 Displaying and Maintaining HABP ConfigurationTo do... Use the command... RemarksDisplay HABPconfiguration and status display habp Available in any viewDisplay the MAC addresstable maintained by HABP display habp table Available in any view
