Operation Manual – Information CenterH3C S5600 Series Ethernet Switches Chapter 1 Information Center1-12II. Enabling system information display on the consoleAfter setting to output system information to the console, you need to enable theassociated display function to display the output information on the console.Follow these steps to enable the system information display on the console:To do… Use the command… RemarksEnable thedebugging/log/trapinformation terminaldisplay functionterminal monitor OptionalEnabled by default.Enable debugginginformation terminaldisplay functionterminal debugging OptionalDisabled by default.Enable log informationterminal display function terminal logging OptionalEnabled by default.Enable trap informationterminal display function terminal trapping OptionalEnabled by default.Note:Make sure that the debugging/log/trap information terminal display function is enabled(use the terminal monitor command) before you enable the corresponding terminaldisplay function by using the terminal debugging, terminal logging, or terminaltrapping command.1.2.5 Setting to Output System Information to a Monitor TerminalSystem information can also be output to a monitor terminal, which is a user terminalthat has login connections through the AUX, VTY, or TTY user interface.I. Setting to output system information to a monitor terminalFollow these steps to set to output system information to a monitor terminalTo do… Use the command… RemarksEnter system view system-view —Enable the informationcenter info-center enable OptionalEnabled by default.