Operation Manual – Routing ProtocolH3C S5600 Series Ethernet Switches Chapter 3 RIP Configuration3-12To do... Use the command... RemarksDisplay RIP routing information display rip routingReset the system configuration relatedto RIP reset Available inRIP view3.7 RIP Configuration ExampleI. Network requirementsA small-sized company requires that any two nodes in its small office networkcommunicate with each other, and that the network devices automatically adaptthemselves to any topology change so as to reduce the work of manual maintenance.In this case, RIP can implement communication between any two nodes.II. Network diagramAccording to the network requirements, the network topology is designed as shown inFigure 3-1.Switch ASwitch BSwitch CVlan-int 2EthernetVlan-int 4 Vlan-int 3Vlan-int 1Device Interface IP address Device Interface IP addressSwitch A Vlan-int1 110.11.2.1/24 Switch B Vlan-int1 110.11.2.2/24Vlan-int2 155.10.1.1/24 Vlan-int3 196.38.165.1/24Switch C Vlan-int1 110.11.2.3/24Vlan-int4 117.102.0.1/16Figure 3-1 Network diagram for RIP configurationIII. Configuration procedureNote:Only the configuration related to RIP is listed below. Before the following configuration,make sure the Ethernet link layer works normally and the IP addresses of VLANinterfaces are configured correctly.