Operation Manual – System Maintenance and DebuggingH3C S5600 Series Ethernet SwitchesChapter 1 Boot ROM and Host SoftwareLoading1-12Switch IP address :10.1.1.2Server IP address :10.1.1.1FTP User Name :SwitchFTP User Password :abcStep 5: Press . The system displays the following information:Are you sure to update your bootrom?Yes or No(Y/N)Step 6: Enter Y to start file downloading or N to return to the Boot ROM update menu. Ifyou enter Y, the system begins to download and update the program. Upon completion,the system displays the following information:Loading........................................doneBootrom updating..........done!z Loading host softwareFollow these steps to load the host software:Step 1: Select <1> in BOOT Menu and press . The system displays thefollowing information:1. Set TFTP protocol parameter2. Set FTP protocol parameter3. Set XMODEM protocol parameter0. Return to boot menuEnter your choice(0-3):Enter 2 in the above menu to download the host software using FTP.The subsequent steps are the same as those for loading the Boot ROM, except for thatthe system gives the prompt for host software loading instead of Boot ROM loading.Caution:When loading the Boot ROM and host software using FTP through BOOT menu, youare recommended to use the PC directly connected to the device as FTP server topromote upgrading reliability.1.3 Remote Boot ROM and Software LoadingIf your terminal is not directly connected to the switch, you can telnet to the switch, anduse FTP or TFTP to load the Boot ROM and host software remotely.