Operation Manual – DHCPH3C S5600 Series Ethernet Switches Chapter 2 DHCP Server Configuration2-13Follow these steps to configure WINS servers for the DHCP client:To do… Use the command… RemarksEnter system view system-view —Enter DHCP address poolviewdhcp server ip-poolpool-name —Configure WINS serveraddresses for DHCPclientsnbns-listip-address&<1-8>RequiredBy default, no WINSserver address isconfigured.Configure DHCP clients tobe of a specific NetBIOSnode typenetbios-type { b-node |h-node | m-node |p-node }OptionalBy default, no NetBIOSnode type of the DHCPclient is specified.Note:If b-node is specified for the client, you don’t need to specify any WINS server address.2.4.8 Configuring Gateways for the DHCP ClientGateways are necessary for DHCP clients to access servers/hosts outside the currentnetwork segment. After you configure gateway addresses on a DHCP server, theDHCP server provides the gateway addresses to DHCP clients as well while assigningIP addresses to them.You can configure gateway addresses for global address pools on a DHCP server.Currently, you can configure up to eight gateway addresses for a DHCP address pool.Follow these steps to configure gateways for the DHCP client:To do… Use the command… RemarksEnter system view system-view —Enter DHCP address poolviewdhcp server ip-poolpool-name —Configure gatewayaddresses for DHCPclientsgateway-listip-address&<1-8>RequiredBy default, no gatewayaddress is configured.