Operation Manual – Auto DetectH3C S5600 Series Ethernet Switches Chapter 1 Auto Detect Configuration1-5To do… Use the command… RemarksEnable the auto detectfunction to implementVLAN interface backupstandby detect-groupgroup-numberRequiredThis operation is onlyneeded on the secondaryVLAN interface.1.3 Auto Detect Configuration Examples1.3.1 Configuration Example for Auto Detect Implementation in StaticRoutingI. Network requirementsz Create detected group 8 on Switch A; detect the reachability of the IP address10.1.1.4, with 192.168.1.2 as the next hop, and the detecting number set to 1.z On switch A, configure a static route to Switch C.z Enable the static route when the detected group 8 is reachable.z To ensure normal operating of the auto detect function, configure a static route toSwitch A on Switch C.II. Network diagramFigure 1-1 Network diagram for implementing the auto detect function in static routeIII. Configuration procedureConfigure the IP addresses of all the interfaces as shown in Figure 1-1. Theconfiguration procedure is omitted.z Configure Switch A.# Enter system view. system-view# Create detected group 8.[SwitchA] detect-group 8# Detect the reachability of 10.1.1.4/24, with 192.168.1.2/24 as the next hop, and thedetecting number set to 1.[SwitchA-detect-group-8] detect-list 1 ip address 10.1.1.4 nexthop192.168.1.2[SwitchA-detect-group-8] quit