Operation Manual – System Maintenance and DebuggingH3C S5600 Series Ethernet Switches Chapter 4 Device Management4-84.3 Displaying the Device Management ConfigurationTo do… Use the command… RemarksDisplay the APP to be adoptedat next startupdisplay boot-loader [ unitunit-id ]Display the module type andoperating status of each boarddisplay device [ manuinfo[ unit unit-id ] | unit unit-id ]Display CPU usage of aswitch display cpu [ unit unit-id ]Display the switch operatingambient display environmentDisplay the operating status ofthe fandisplay fan [ unit unit-id[ fan-id ] ]Display memory usage of aswitchdisplay memory [ unit unit-id |limit ]Display the operating status ofthe power supplydisplay power [ unit unit-id[ power-id ] ]Display system diagnosticinformation or save systemdiagnostic information to a filewith the extension .diag intothe Flash memorydisplaydiagnostic-informationDisplay enabled debugging ona specified switch or allswitches in the fabricdisplay debugging { fabric |unit unit-id } [ interfaceinterface-typeinterface-number ][ module-name ]Display enabled debugging onall switches in the fabric bymodulesdisplay debugging fabricby-moduleDisplay patch stateinformation display patch-informationAvailable in anyview.4.4 Remote Switch APP Upgrade Configuration ExampleI. Network requirementsTelnet to the switch from a PC remotely and download applications from the FTP serverto the Flash memory of the switch. Update the switch software by using the devicemanagement commands through CLI.The switch acts as the FTP client, and the remote PC serves as both the configurationPC and the FTP server.Perform the following configuration on the FTP server.