Operation Manual – MSTPH3C S5600 Series Ethernet Switches Chapter 1 MSTP Configuration1-34II. Specify whether the link connected to a port is point-to-point link inEthernet port viewFollow these steps to specify whether the link connected to a port is point-to-point link inEthernet port view:To do... Use the command... RemarksEnter system view system-view —Enter Ethernet port view interface interface-typeinterface-number —Specify whether the linkconnected to a port is apoint-to-point linkstp point-to-point{ force-true | force-false |auto }RequiredThe auto keyword isadopted by default.Note:z If you configure the link connected to a port in an aggregation group as apoint-to-point link, the configuration will be synchronized to the rest ports in thesame aggregation group.z If an auto-negotiating port operates in full duplex mode after negotiation, you canconfigure the link of the port as a point-to-point link.After you configure the link of a port as a point-to-point link, the configuration applies toall the MSTIs the port belongs to. If the actual physical link of a port is not apoint-to-point link and you forcibly configure the link as a point-to-point link, loops mayoccur temporarily.III. Configuration example# Configure the link connected to GigabitEthernet 1/0/1 as a point-to-point link.1) Perform this configuration in system view system-view[Sysname] stp interface GigabitEthernet 1/0/1 point-to-point force-true2) Perform this configuration in Ethernet port view system-view[Sysname] interface GigabitEthernet 1/0/1[Sysname-GigabitEthernet1/0/1] stp point-to-point force-true1.3.14 Enabling MSTPI. Configuration procedureFollow these steps to enable MSTP in system view:
