Operation Manual – DLDPH3C S5600 Series Ethernet Switches Chapter 1 DLDP Configuration1-121.3.3 Displaying and Maintaining DLDPTo do … Use the command … RemarksDisplay the DLDPconfiguration of a unit or aportdisplay dldp { unit-id |interface-typeinterface-number }Available in any view.1.4 DLDP Configuration ExampleI. Network requirementsAs shown in Figure 1-3,z Switch A and Switch B are connected through two pairs of fibers. Both of themsupport DLDP. All the ports involved operate in mandatory full duplex mode, withtheir rates all being 1,000 Mbps.z Suppose the fibers between Switch A and Switch B are cross-connected. DLDPdisconnects the unidirectional links after detecting them.z After the fibers are connected correctly, the ports shut down by DLDP arerestored.II. Network diagramSwitchBSwitchAPCSwitchBSwitchAPCSwitchBSwitchAPCSwitchBSwitchAPCGE1/0/50 GE1/0/51GE1/0/50 GE1/0/51Figure 1-3 Network diagram for DLDP configurationIII. Configuration procedure1) Configure Switch A# Configure the ports to work in mandatory full duplex mode at a rate of 1000 Mbps. system-view[SwitchA] interface gigabitethernet 1/0/50[SwitchA-GigabitEthernet1/0/50] duplex full[SwitchA-GigabitEthernet1/0/50] speed 1000[SwitchA-GigabitEthernet1/0/50] quit[SwitchA] interface gigabitethernet 1/0/51[SwitchA-GigabitEthernet1/0/51] duplex full