Operation Manual – 802.1x and System GuardH3C S5600 Series Ethernet Switches Chapter 1 802.1x Configuration1-22Note:As for the dot1x version-user command, if you execute it in system view withoutspecifying the interface-list argument, the command applies to all ports. You can alsoexecute this command in port view. In this case, this command applies to the currentport only and the interface-list argument is not needed.1.4.3 Enabling DHCP-triggered AuthenticationAfter performing the following configuration, 802.1x allows running DHCP on accessusers, and users are authenticated when they apply for dynamic IP addresses throughDHCP.Follow these steps to enable DHCP-triggered authentication:To do... Use the command... RemarksEnter system view system-view —Enable DHCP-triggeredauthentication dot1x dhcp-launchRequiredBy default,DHCP-triggeredauthentication is disabled.1.4.4 Configuring Guest VLANFollow these steps to configure guest VLAN:To do... Use the command... RemarksEnter system view system-view —Configure port accessmethoddot1x port-methodportbasedRequiredThe default port accessmethod isMAC-address-based.That is, the macbasedkeyword is used bydefault.In systemviewdot1x guest-vlan vlan-id[ interface interface-list ]interface interface-typeinterface-numberdot1x guest-vlan vlan-idEnable theguestVLANfunction In port viewquitRequiredBy default, the guestVLAN function is disabled.
