Operation Manual – LoginH3C S5600 Series Ethernet SwitchesChapter 5 Logging In Through the Web-basedNetwork Management System4-2AT&K0 ----------------------- Disable flow controlAT&R1 ----------------------- Ignore RTS signalAT&S0 ----------------------- Set DSR to high level by forceATEQ1&W ----------------------- Disable the Modem from returning commandresponse and the result, save the changesYou can verify your configuration by executing the AT&V command.Note:The configuration commands and the output of different modems may differ. Refer tothe user manual of the modem when performing the above configuration.4.2.2 Switch ConfigurationNote:After logging in to a switch through its console port by using a modem, you will enter theAUX user interface. The corresponding configuration on the switch is the same asthose when logging in to the switch locally through its console port except that:z When you log in through the console port using a modem, the baud rate of theconsole port is usually set to a value lower than the transmission speed of themodem. Otherwise, packets may get lost.z Other settings of the console port, such as the check mode, the stop bits, and thedata bits, remain the default.The configuration on the switch depends on the authentication mode the user is in.Refer to Table 2-3 for the information about authentication mode configuration.I. Configuration on switch when the authentication mode is noneRefer to Console Port Login Configuration with Authentication Mode Being None.II. Configuration on switch when the authentication mode is passwordRefer to Console Port Login Configuration with Authentication Mode Being Password.III. Configuration on switch when the authentication mode is schemeRefer to Console Port Login Configuration with Authentication Mode Being Scheme.
