Operation Manual – MAC Address Table ManagementH3C S5600 Series Ethernet SwitchesChapter 1 MAC Address TableManagement1-10z DLDPPort MAC address configuration does not affect service packet forwarding.1.3 Displaying MAC Address Table InformationTo do… Use the command… RemarksDisplay information about the MACaddress tabledisplay mac-address[ display-option ]Display the aging time of thedynamic MAC address entries inthe MAC address tabledisplay mac-addressaging-timeDisplay the configured start portMAC address display port-macAvailable inany view1.4 Configuration Example1.4.1 Adding a Static MAC Address Entry ManuallyI. Network requirementsThe server connects to the switch through GigabitEthernet 1/0/2. To prevent the switchfrom broadcasting packets destined for the server, it is required to add the MACaddress of the server to the MAC address table of the switch, which then forwardspackets destined for the server through GigabitEthernet 1/0/2.z The MAC address of the server is 000f-e20f-dc71.z Port GigabitEthernet 1/0/2 belongs to VLAN 1.II. Configuration procedure# Enter system view. system-view[Sysname]# Add a MAC address, with the VLAN, ports, and states specified.[Sysname] mac-address static 000f-e20f-dc71 interface GigabitEthernet 1/0/2vlan 1# Display information about the current MAC address table.[Sysname] display mac-address interface GigabitEthernet 1/0/2Unit 1MAC ADDR VLAN ID STATE PORT INDEX AGING TIME(s)000f-e20f-dc71 1 Config static GigabitEthernet1/0/2 NOAGED000f-e20f-a7d6 1 Learned GigabitEthernet1/0/2 AGING000f-e20f-b1fb 1 Learned GigabitEthernet1/0/2 AGING