Operation Manual – HWPingH3C S5600 Series Ethernet Switches Chapter 1 HWPing Configuration1-2Switch A Switch BHWPing ClientIP networkHWPing ServerFigure 1-1 HWPing illustration1.1.2 Test Types Supported by HWPingAmong the test types supported by HWPing, only the ICMP test can be performedwhen IRF fabric is enabled; all other test types cannot be performed when IRF fabric isenabled.Table 1-1 Test types supported by HWPingSupported test types DescriptionICMP testDHCP testFTP testHTTP testDNS testSNMP testFor these types of tests, you need to configureHWPing client and corresponding servers.Jitter testTcppublic testTCP testTcpprivate testUdppublic testUDP testUdpprivate testz These types of tests need the cooperation of theHWPing client and HWPing server.z Do not perform a TCP, UDP or jitter test on awell-known port (ports with a number ranging from1 to 1023) or on a port with a port number greaterthan 50000. Otherwise, your HWPing test may failor the service corresponding to the well-knownport may become unavailable.1.1.3 HWPing Test ParametersYou need to configure corresponding test parameters for each type of HWPing test.HWPing test parameters can be configured on HWPing client only. For theconfigurations on HWPing client, refer to section HWPing Client Configuration.Table 1-2 HWPing test parametersTest parameter DescriptionDestination address(destination-ip)For TCP/UDP/jitter test, you must specify a destinationIP address, and the destination address must be the IPaddress of a TCP/UDP/UDP listening serviceconfigured on the HWPing server.