Operation Manual – PoE-PoE ProfileH3C S5600 Series Ethernet Switches Chapter 1 PoE Configuration1-81.2.10 Displaying PoE ConfigurationTo do… Use the command… RemarksDisplay the PoE status of aspecific port or all ports of theswitchdisplay poe interface[ interface-typeinterface-number ]Display the PoE powerinformation of a specific portor all ports of the switchdisplay poe interface power[ interface-typeinterface-number ]Display the PSE parameters display poe powersupplyDisplay the status(enabled/disabled) of the PoEover-temperature protectionfeature on the switchdisplay poetemperature-protectionAvailable in anyview1.3 PoE Configuration Example1.3.1 PoE Configuration ExampleI. Network requirementsSwitch A is an S5600 series Ethernet switch supporting PoE, Switch B can be PoEpowered.z The GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2 ports of Switch A areconnected to Switch B and an AP respectively; the GigabitEthernet 1/0/8 port isintended to be connected with an important AP.z The PSE processing software of Switch A is first upgraded online. The remotelyaccessed PDs are powered by Switch A.z The power consumption of the accessed AP is 2,500 mW, and the maximumpower consumption of Switch B is 12,000 mW.z It is required to guarantee the power feeding to the PDs connected to theGigabitEthernet 1/0/8 port even when Switch A is under full load.