Operation Manual – Routing ProtocolH3C S5600 Series Ethernet Switches Chapter 2 Static Route Configuration2-3Note:z Use the ip route-static command to configure a default route by setting thedestination IP address and the mask to 0.0.0.0.z Avoid configuring the next hop address of a static route to the address of aninterface on the local switch.z Different preferences can be configured to implement flexible route managementpolicies.z For automatic detection information, refer to the part discussing Auto Detect.2.3 Displaying and Maintaining Static RoutesTo do... Use the command... RemarksDisplay the currentconfiguration information display current-configurationDisplay the brief informationof a routing table display ip routing-tableDisplay the detailedinformation of a routing table display ip routing-table verboseDisplay the information ofstatic routesdisplay ip routing-table protocolstatic [ inactive | verbose ]Available inany viewDelete all static routes delete static-routes all Available insystem view2.4 Static Route Configuration ExampleI. Network requirementsA small company requires that any two nodes in its office network communicate witheach other, and that the network structure be simple and stable. The company hopesthat the existing devices that do not support any dynamic routing protocol can be fullyutilized.In this case, static routes can implement communication between any two nodes.II. Network diagramAccording to the network requirements, the network topology is designed as shown inFigure 2-1.
