10-15MNT MaintenanceChecking the PCV1. Check the PCV. See “Checking the PCV”(7-34).Checking the PTT fluid level1. Check the PTT fluid level. See “Checkingthe hydraulic pressure” (9-34).Checking the PTT operation1. Tilt the outboard motor to the fully up andfully down positions a few times andcheck the entire trim range for smoothoperation. Check the PTT fluid level if thetilt operation is not smooth.TIP:Make sure to listen to the winding sound ofthe PTT motor for smooth operation.2. Tilt the outboard motor to the fully upposition, and then support it with the tiltstop lever a to check the lockmechanism of the lever.Checking the propeller1. Check the propeller blades and splines.Replace the propeller if cracked, dam-aged, or worn.Checking the spark plug1. Disconnect the spark plug wire, and thenremove the spark plug.2. Clean the electrode a with a spark plugcleaner or wire brush.3. Check the spark plug. Replace if theelectrodes are eroded, there is excessivecarbon or other deposits, or the gasket isdamaged.4. Check the spark plug gap a. Adjust thespark plug gap if out of specification.aSpecified spark plug:LFR5A-11 (NGK)Spark plug gap a:1.0–1.1 mm (0.039–0.043 in)aa