Yamaha F150B Service Manual

Also see for F150B: Owner's manual Service manual Owner's manual

3-11RIGGING Rigging information5. Adjust the cable joint a to the pin c ofthe throttle cam. WARNING! Thethrottle cable joint must be screwed ina minimum 8.0 mm (0.31 in).6. If the cable joint is not maintained theengagement of minimum 8.0 mm(0.31 in) d, remove the bolts f andremount the holder with the holes e orf.7. Install the cable joint a to the pin c, andsecure it with the clip g.TIP:Pull the inner cable to avoid the free play(backlash) of the cable, and install it to thepin.8. Tighten the locknut h to the specifiedtorque.9. Check the throttle cable for properoperation.Installing the isolator lead (option)Carry out the following procedures only whenthe isolator lead (option) is used.1. Remove the cap a from the isolator cou-pler.2. Connect the isolator lead b it’s coupler.Installing the gauge harnessSee “Rigging guide” for the installation of thegauge to the boat.1. Remove the coupler a from the bracketa.Dimension d: 8.0 mm (0.31 in)caadfefLocknut h: 5 N·m (0.5 kgf·m, 3.7 ft·lb)acghab