CHAPTER 1 - HARDWARELightsheet Z.1 User Interfaces Carl Zeiss02/2013 000000-1790-528 353.6 Inserting and Removing theSample Holder• To insert the sample holder move the stage ofthe Lightsheet Z.1 system to the Load positionvia the Specimen Navigator tool (Fig. 28) inthe ZEN software (see CHAPTER 4 SYSTEMOPERATION).• Open the upper system cavity door (Fig. 28/1).• Take the sample holder for capillaries or syringes by the sample holder disc with the capillary or thesyringe facing downwards (Fig. 29/3).• Insert the sample holder gliding the sample holder disc along the guide rails (Fig. 29/2). It is placedcorrectly into a click position if the sample holder disc ball bearings lock into the three holes.• Notice the white line marking at the outer edge of the disc. It can be used as a reference point forreorienting the sample holder disc once it was taken out.• Close the upper system cavity door (Fig. 29/1) and position the capillary and the sample as described inCHAPTER 4 SYSTEM OPERATION.1 Sample holder disc for syringes 4 Ball bearings2 Adapter ring 5 Syringe body3 Syringe 6 ClampFig. 27 Assembly of sample holder for syringesFig. 28 Load Position in the SpecimenNavigator