IPv6 Routing Commands 1093ipv6 nd managed-config-flagUse the ipv6 nd managed-config-flag command in Interface Configurationmode to set the “managed address configuration” flag in routeradvertisements. When the value is true,end nodes use DHCPv6. When the value is false, end nodes automaticallyconfigure addresses.Syntaxipv6 nd managed-config-flagno ipv6 nd managed-config-flagDefault ConfigurationFalse is the default configuration.Command ModeInterface Configuration (VLAN, Tunnel, Loopback) modeUser GuidelinesThis command has no user guidelines.ExampleIn the following example, the end node uses DHCPv6.console(config)#interface vlan 15console(config-if-vlan15)#ipv6 nd managed-config-flagipv6 nd ns-intervalUse the ipv6 nd ns-interval command in Interface Configuration mode to setthe interval between router advertisements for advertised neighborsolicitations. An advertised value of 0 means the interval is unspecified.Syntaxipv6 nd ns-intervalmillisecondsno ipv6 nd ns-interval
