532 IP Source Guard CommandsUser GuidelinesThe configured IP address and MAC address are used to match the source IPaddress and source MAC address for packets received on the interface. Hostssending packets using the configured source IP address and source MACaddress are trusted on the interface.Exampleconsole(config)#ip verify binding 00:11:22:33:44:55 vlan 1 1.2.3.4 interfacegigabitethernet 1/0/2show ip verifyUse the show ip verify command to display the IP Source Guardconfiguration on all interfaces or the specified interface.Syntaxshow ip verify [interfaceif-id]•if-id—A valid interface ID (physical)Default ConfigurationThere is no default configuration for this command.Command ModesUser EXEC, Privileged EXEC (all show modes)User GuidelinesThe filter type is one of the following values:• ipv4-mac: User has configure MAC address filtering on this interface• ip: IPv4 address filtering is configured on this interface• N/A: No filtering is configured on the interfaceExampleconsole(config-if-Gi1/0/5)#show ip verifyInterface Filter Type
