OSPF Commands 1233console(config-if-vlan1)#ip ospf retransmit-interval 50ip ospf transmit-delayUse the ip ospf transmit-delay command in Interface Configuration mode toset the OSPF Transit Delay for the specified interface. Use the no form of thecommand to return the delay to the default value.Syntaxip ospf transmit-delaysecondsno ip ospf transmit-delay•seconds — Sets the estimated number of seconds it takes to transmit a linkstate update packet over this interface. (Range: 1–3600 seconds)Default Configuration1 is the default number of seconds.Command ModeInterface Configuration (VLAN) mode.User GuidelinesThis command has no user guidelines.ExampleThe following example sets the OSPF Transit Delay for VLAN 15 at 20seconds.console(config-if-vlan1)#ip ospf transmit-delay 20log adjacency-changesUse the log adjacency-changes command in OSPFv2 Router Configurationmode to enable logging of OSPFv2 neighbor state changes.Use the no form of the command to disable state change logging.
