IPv6 Multicast Commands 116752IPv6 Multicast CommandsDell Networking N3000/N4000 Series SwitchesThe Dell Network N2000 series supports limited routing and multicast capabilities.See the Users Configuration Guide section “Feature Limitations and PlatformConstants” for supported capabilities.This chapter explains the following commands:clear ipv6 mrouteThis command is used to selectively clear dynamic IPv6 multicast entriesfrom the cache.Syntaxclear ipv6 mroute { * |group-address [source-address ] }* —Deletes all IPv6 entries from the IP multicast routing table.group-address— IPv6 address of the multicast group.source-address—IPv6 address of a multicast srouce that is sending multicasttraffic to the group.clear ipv6 mroute ipv6 pim rp-addressipv6 pim (VLAN Interface config) ipv6 pim rp-candidateipv6 pim bsr-border ipv6 pim sparse-modeipv6 pim bsr-candidate ipv6 pim ssmipv6 pim dense-mode show ipv6 pimipv6 pim dr-priority ipv6 pim dense-modeipv6 pim hello-interval show ipv6 pim interfaceipv6 pim join-prune-interval show ipv6 pim neighboripv6 pim register-threshold show ipv6 pim rp-hash– show ipv6 pim rp mapping
