Green Ethernet Commands 433be disabled. An error message (Unable to set energy-detectmode) will be displayed if the user attempts to configure energy-detect on a10G port on a N2000/N3000 series switch.green-mode eeeUse the green-mode eee command in Interface Configuration mode toenable EEE low power idle mode on an interface. The command enables bothsend and receive sides of a link to disable some functionality for power savingswhen lightly loaded. Transition to Low Power Mode does not change the linkstatus. Frames in transit are not dropped or corrupted in transition to andfrom Low Power Mode.On combo ports, eee mode can be enabled even if the port is using the fiberinterface. If enabled, eee mode is only active when the copper interface isactive.Use the no form of the command to disable the feature.Syntaxgreen-mode eeeno green-mode eeeDefault ConfigurationThe default value is Disabled.Command ModeInterface ConfigurationUser GuidelinesCable diagnostics (show copper-ports commands) may give misleadingresults if green mode is enabled on the port. Disable green mode prior torunning any cable diagnostics. EEE mode is supported on N4000 series 10Gcopper ports and on N2000/N3000 1G and 10G copper interfaces.
