Green Ethernet Commands 435Syntaxgreen-mode eee-lpi-history {sampling-interval30 sec –36000 sec| max-samples1 -168}• sampling-interval—The interval in seconds at which power consumptiondata needs to be collected.• max-samples—Maximum number of samples to keep.Default ConfigurationThe sampling-interval default value is 3600 seconds and the max-samplesdefault value is 168.Command ModeGlobal ConfigurationUser GuidelinesEEE and energy-detect modes are only supported on N4000 series 10Gcopper ports and on N2000/N3000 1G and 10G copper ports.ExamplesUse the command below to set the EEE LPI History sampling interval to thedefault.console(config)# no green-mode eee-lpi-history sampling-intervalUse the command below to set the EEE LPI History max-samples to thedefault.console(config)#no green-mode eee-lpi-history max-samplesshow green-modeinterface-idUse the show green-modeinterface-id command in Privileged EXEC modeto display the green-mode configuration and operational status of the port.This command is also used to display the per port configuration andoperational status of the green-mode. The status is shown only for the modessupported on the corresponding hardware platform whether enabled ordisabled.
