1388 Auto-Install Commands4 Support for the Auto-Install process from a TFTP server operationallyenabling the DHCP client on designated management interfaces duringthe Auto-Install process. The end user configuration remains unchanged.Management interfaces include the out-of-band interface or routinginterfaces in a saved config.Commands in this ChapterThis chapter explains the following commands:boot auto-copy-swUse the boot auto-copy-sw command in Privileged EXEC mode to enable ordisable Stack Firmware Synchronization.Use the no form of the command to disable Stack Firmware Synchronization.Syntaxboot auto-copy-swno boot auto-copy-swDefault ConfigurationStack firmware synchronization is enabled by default.Command ModeGlobal Configboot auto-copy-sw boot auto-copy-sw allow-downgradeboot host autoreboot boot host autorebootboot host autosave boot host autosaveboot host dhcp boot host dhcpboot host retrycount boot host retrycountboot auto-copy-sw show auto-copy-sw– show boot
