444 GVRP CommandsSyntaxclear gvrp statistics [{gigabitethernet unit/slot/port | port-channelport-channel-number | tengigabitethernet unit/slot/port | fortygigabitethernetunit/slot/port}]Default ConfigurationThis command has no default configuration.Command ModePrivileged EXEC modeUser GuidelinesThis command has no user guidelines.ExampleThe following example clears all the GVRP statistics information on port1/0/8.console# clear gvrp statistics gigabitethernet 1/0/8garp timerUse the garp timer command in Interface Configuration mode to adjust theGARP application join, leave, and leaveall GARP timer values. To reset thetimer to default values, use the no form of this command.Syntaxgarp timer {join | leave | leaveall}timer_valueno garp timer• join — Indicates the time in centiseconds that PDUs are transmitted.• leave — Indicates the time in centiseconds that the device waits beforeleaving its GARP state.• leaveall — Used to confirm the port within the VLAN. The time is theinterval between messages sent, measured in centiseconds.
