1278 OSPFv3 Commandsarea default-cost (Router OSPFv3)Use the area default-cost command in Router OSPFv3 Configuration modeto configure the monetary default cost for the stub area. The operator mustspecify the area id and an integer value between 1-16777215. Use the no formof the command to return the cost to the default value. If the area has notbeen previously created, this command creates the area and then applies thedefault-cost.Syntaxareaarea-id default-costcostno areaarea-id default-cost•areaid — Valid area identifier.•cost — Default cost. (Range: 1-16777215)Default ConfigurationThis command has no default configuration.Command ModeRouter OSPFv3 Configuration modeUser GuidelinesThis command has no user guidelines.area virtual-link ipv6 ospf dead-intervalpassive-interfacedefaultshow ipv6 ospf rangearea virtual-linkdead-intervalipv6 ospf hello-intervalredistribute show ipv6 ospf stubtablearea virtual-linkhello-intervalipv6 ospf mtu-ignorerouter-id show ipv6 ospf virtual-linksarea virtual-linkretransmit-intervalipv6 ospf network show ipv6 ospf show ipv6 ospf virtual-link brief
