1496 Management ACL Commandsdeny (management)Use the deny command in Management Access-List Configuration mode toset conditions for the management access list.Syntaxdeny [gigabitethernet unit/slot/port | vlanvlan-id | port-channelport-channel-number | tengigabitethernet unit/slot/port | fortygigabitethernetunit/slot/port] [serviceservice] [prioritypriority]deny ip-sourceip-address [maskmask |prefix-length] [gigabitethernetunit/slot/port | vlanvlan-id | port-channelport-channel-number |tengigabitethernet unit/slot/port | fortygigabitethernet unit/slot/port][serviceservice] [prioritypriority]• gigabitethernet unit/slot/port — A valid 1-gigabit Ethernet-routed portnumber.• vlanvlan-id — A valid VLAN number.• port-channelport-channel-number — A valid routed port-channelnumber.• tengigabitethernet unit/slot/port — A valid 10-gigabit Ethernet-routedport number.• fortygigabitethernet unit/slot/port– A valid 40-gigabit Ethernet-routedport number.•ip-address — Source IP address.• maskmask — Specifies the network mask of the source IP address.• maskprefix-length — Specifies the number of bits that comprise thesource IP address prefix. The prefix length must be preceded by a forwardslash (/). (Range: 0–32)• serviceservice — Indicates service type. Can be one of the following:telnet, ssh, http, https, tftp, snmp, sntp, or any. The any keyword indicatesthat the service match for the ACL is effectively "don’t care".• prioritypriority — Priority for the rule. (Range: 1–64)management access-list show management access-list
