358 E-mail Alerting CommandsCommands in this ChapterThis chapter explains the following commands:logging emailUse the logging email command in Global Configuration mode to enable e-mail alerting and set the lowest severity level for which log messages are e-mailed. Use the no form of the command to disable e-mail alerting.Syntaxlogging email [severity]no logging email•severity—If you specify a severity level, log messages at or above theseverity level are e-mailed. The severity level may either be specified bykeyword or as an integer from 0 to 7. The accepted keywords, and thenumeric severity level each represents, are as follows.– emergency (0)– alert (1)– critical (2)– error (3)– warning (4)logging email show logging email statisticslogging email urgent clear logging email statisticslogging traps securitylogging email message-type to-addr mail-server ip-address | hostnamelogging email from-addr port (Mail Server Configuration Mode)logging email message-type subject username (Mail Server ConfigurationMode)logging email logtime password (Mail Server ConfigurationMode)logging email test message-type show mail-server
