IPv6 Multicast Commands 1175User GuidelinesThere are no user guidelines for this command.Exampleconsole(config)#ipv6 pim rp-address 2001::1 ff1e::/64ipv6 pim rp-candidateUse the ipv6 pim rp-candidate command to configure the router to advertiseitself as a PIM candidate rendezvous point (RP) to the bootstrap router(BSR). Use the no form of this command to disable the router fromadvertising itself as a PIM candidate rendezvous point (RP) to the bootstraprouter (BSR).Syntaxipv6 pim rp-candidate vlanvlan-id group-address/prefixlength [intervalc_rp_interval ]no ipv6 pim rp-candidate vlanvlan-id• vlan-id— A valid VLAN ID value.• group-address—The group address to display.• prefixlength—This parameter specifies the prefix length of the IP addressfor the media gateway. (Range: 1–32)• c_rp_interval—The Candiate RP advertisement interval (range 1-16383seconds, default 60 seconds).Default ConfigurationThe router does not advertise itself as a PIM candidate rendezvous point bydefault.Command ModeGlobal Configuration modeUser GuidelinesThe default interval for a Candidate Rendezvous Point (C-RP) to send C-RPAdvertisement messages to the Bootstrap Router (BSR) is 60 seconds.
