LLDP Commands 559User GuidelinesThis command has no user guidelines.ExampleThe following example displays how to enable the LLDP receive capability.console(config-if-Gi1/0/3)#lldp receivelldp timersUse the lldp timers command in Global Configuration mode to set thetiming parameters for local data transmission on ports enabled for LLDP. Toreturn any or all parameters to factory default, use the no form of thiscommand.Syntaxlldp timers [interval transmit-interval] [hold hold-multiplier] [reinit reinit-delay]no lldp timers [interval] [hold] [reinit]•transmit-interval — The interval in seconds at which to transmit local dataLLDPDUs. (Range: 5–32768 seconds)•hold-multiplier — Multiplier on the transmit interval used to set the TTLin local data LLDPDUs. (Range: 2–10)•reinit-delay — The delay in seconds before reinitialization. (Range: 1–10seconds)Default ConfigurationThe default transmit interval is 30 seconds.The default hold-multiplier is 4.The default delay before reinitialization is 2 seconds.Command ModeGlobal Configuration mode
